Sunday, September 14, 2008

Cutting New Steam Gear Stencil Designs

This is an idea that's been bouncing around inside my head for the past few weeks. It's a geared and steam motif design for a small experimental series of cups and canisters. This project uses the strategy of using cut paper stencils and slips to create compositions to be used as the base designs. After the pieces are glazed, they are then enhanced with a collage layer of home printed high iron decals that are then refired onto the finished surface.

To create enough stencils to play with, I make a stack of 32 sheets of newsprint sandwiched between 2 sheets of thin plastic posterboard. The edges are taped up and a pos/neg design is rubber cemented to the surface. The design is then pierced with a thin drill bit to allow a jewelers saw blade to be threaded though and cut away the design.



The plastic on the exterior of the stack gives the stack a workable level of stiffness. With practice, imagination, and patience, you can get pretty noodley with your designs.

I like mixing and matching stencils to create my designs. I usually start off working to create a specific composition... just to see what it looks like. But after that though, the work turns to a pure freeform and organic style of composition.

This is where I get to fall into a nighttime groove... it's all about the Jazz... the surprises of a flow...it's where the racers happen...

3 comments:

Wenchie said...

I can't wait to see the finished product! I need to work overtime on my shop so I can buy one of these once they are done ^_^.

Hyla said...

Kick Ass! over seeing the in progress. And this is up in a time for me to enjoy, 2 am in the morning!
The power keeps going on and off here, making it very difficult to sleep :(
~Hyla

Sarah Dungan said...

So when do I get mine? ;-)